利用漏率间接测量密封件真空度方法的研究

doi:10.13385/j.cnki.vacuum.2021.03.12

真空 ›› 2021, Vol. 58 ›› Issue (3): 59-64.doi: 10.13385/j.cnki.vacuum.2021.03.12

利用漏率间接测量密封件真空度方法的研究

刘国庭, 成永军, 陈联, 王玉洁, 孙雯君, 董猛, 吴成耀, 宋伊, 魏宁斐

兰州空间技术物理研究所真空技术与物理重点实验室甘肃兰州 730000

收稿日期:2020-06-19 出版日期:2021-05-25 发布日期:2021-06-01
通讯作者: 成永军,博士,研究员。
作者简介:刘国庭（1995-）,男,甘肃省白银市人,硕士。

Study on the Method of Indirectly Measuring the Vacuum Degree of Seals by Using Leakage Rate

LIU Guo-ting, CHENG Yong-jun, CHEN Lian, WANG Yu-jie, SUN Wen-jun, DONG Meng, WU Cheng-yao, SONG Yi, WEI Ning-fei

Science and Technology on Vacuum Technology and Physcis Laboratory,Lanzhou Institude of Physics,Lanzhou 730000,China

Received:2020-06-19 Online:2021-05-25 Published:2021-06-01

摘要/Abstract

摘要： 本文提出利用漏率间接测量真空度的方法,解决密封件腔内真空度的测量问题。在此基础上开展相关实验,探究该方法在实际应用中的可行性以及相关适用条件等。实验以连接不同尺寸规格金属毛细管的模拟件为研究对象,利用动态流量法测量模拟件的漏率,进而间接获得模拟件的腔内真空度。实验结果表明,利用漏率间接测得的模拟件真空度与利用皮拉尼规原位测得的模拟件真空度的偏差在15%左右,偏差较小。同时实验中还发现该方法存在包括测量范围、反应时间等限制性适用条件,并在理论上做了合理的解释,进而完备了该方法,并为实际应用奠定了基础。

关键词: 密封件, 间接测量真空度, 漏率, 流导, 动态流量法, 毛细管

Abstract: This paper proposes a method to indirectly measure the vacuum degree using the leak rate to solve the problem of measuring the vacuum degree in the seal cavity. On this basis,relevant experiments are carried out to explore the feasibility of the method in practical applications and relevant applicable conditions. The experiment takes a simulation part connected with metal capillaries of different sizes as the research object,and uses the dynamic flow method to measure the leakage rate of the simulation part,thereby indirectly obtaining the vacuum degree in the cavity of the simulation part. The experimental results show that the difference between the vacuum of the simulated part measured indirectly using the leak rate and the vacuum of the simulated part measured in situ using the Pirani gauge is about 15%,and the deviation is small. At the same time,the experiment also indicated that the method has restrictive applicable conditions including measurement range,reaction time and so on,and made a reasonable explanation in theory,and then perfected the method and laid the foundation for practical application.

Key words: seal, indirect measurement of vacuum, leakage rate, conductance, dynamic flow method, capillary

中图分类号:

TB77

刘国庭, 成永军, 陈联, 王玉洁, 孙雯君, 董猛, 吴成耀, 宋伊, 魏宁斐. 利用漏率间接测量密封件真空度方法的研究[J]. 真空, 2021, 58(3): 59-64.

LIU Guo-ting, CHENG Yong-jun, CHEN Lian, WANG Yu-jie, SUN Wen-jun, DONG Meng, WU Cheng-yao, SONG Yi, WEI Ning-fei. Study on the Method of Indirectly Measuring the Vacuum Degree of Seals by Using Leakage Rate[J]. VACUUM, 2021, 58(3): 59-64.

参考文献

[1] 徐海峰, 王波, 罗高乔, 等. 大冷量气体轴承斯特林制冷机与杜瓦耦合漏热分析[J]. 低温与超导, 2020, 48(4): 15-18+72.
[2] 张亚平, 朱颖峰, 徐冬梅, 等. 提升红外焦平面探测器杜瓦组件的储存寿命[J]. 真空科学与技术学报, 2018, 38(8): 643-649.
[3] 宋萌, 王利琴, 李敬东, 等. 100kJ高温超导磁储能系统的低温杜瓦设计[J]. 低温与超导, 2013, 41(4):4-7+30.
[4] WANG D L, LI J J, WANG X H, et al. Measurement of gas permeation through packaging materials of OLED by mass spectrometry[A]. Proc. SPIE7658, 5th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Optoelectronic Materials and Devices for Detector, Imager, Display, and Energy Conversion Technology[C/OL]. 2010[2010-10-22]. https://doi.org/10.1117/12.866110.
[5] CHOI B D, KAKKAD R.Enhancement of Solid-phase Crystallization Kinetics of Amorphous Silicon by Annealing in a High-pressure H₂O Ambien[J]. Journal of the Korean Physical Society, 2009, 55(1): 1-4.
[6] 陈联, 董猛, 刘国庭, 等. 电真空器件在轨加电时腔体压力变化分析[J]. 真空, 2020, 57(3): 61-66.
[7] 王帆, 刘磊, 张胜兵, 等. 一种MEMS陀螺晶圆级真空封装工艺[J]. 微纳电子技术, 2019, 56(3): 248-252.
[8] KIM J S, LEE S W, JUNG K D, et al.Quality factor measurement of micro gyroscope structure according to vacuum level and desired Q-factor range package method[J]. Microelectronics Reliability, 2008, 48(6): 948-952.
[9] 黄炜昭. 变压器密封失效分析及防治措施研究[J]. 变压器, 2014, 51(5): 59-61.
[10] 杨奇岭, 赵峰. 变压器密封橡胶的老化[J]. 变压器, 2001, 38(6): 7-9.
[11] 朱绪飞, 文威, 贾红兵, 等. 电容器密封橡胶及其老化机理[J]. 弹性体, 2002, 12(1): 58-62.
[12] 赵耀洪, 钱艺华, 陈天生, 等. SF6气密封橡胶材料气体渗透特性研究[J]. 变压器, 2019, 55(10): 0116-0120.
[13] SONEY C, GEORGE A, NINAN K N, et al.Permeation of nitrogen and oxygen gases through styrene-butadiene rubber,natural rubber and styrene-butadiene rubber/natural rubber blend membranes[J]. European Polymer Journal, 2001, 37(1): 183-191.
[14] DENISOV E A, KOMPANIETS M V, KOMPANIETS T N, et al.Surface-limited permeation regime in the study of hydrogen interactions with metals[J]. Measurement, 2018, 117: 258-265.
[15] 王静, 李军建, 吴启鹏. 阻隔材料的气体渗透率[J]. 强激光与粒子束, 2012, 24(7): 1619-1623.
[16] 达道安. 真空设计手册: 第3版[M]. 北京: 国防科技工业出版社, 2004, 116-1131.

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed

利用漏率间接测量密封件真空度方法的研究

Study on the Method of Indirectly Measuring the Vacuum Degree of Seals by Using Leakage Rate

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 8

Metrics

本文评价

推荐阅读 0

[1]	蔡潇, 曹曾, 张炜, 李瑞鋆, 黄勇. HL-2M装置真空室预抽气系统的研制^*[J]. 真空, 2021, 58(1): 33-37.
[2]	贺平. 复合材料筒体泄漏率测试方法研究[J]. 真空, 2020, 57(6): 54-58.
[3]	张海峰, 孙立臣, 郭崇武, 齐飞飞, 李文斌. 生物试验载荷压升法总漏率测试技术研究^*[J]. 真空, 2020, 57(4): 46-49.
[4]	任国华, 李征, 孙立志, 窦仁超, 孟冬辉, 张海峰, 赵月帅, 闫荣鑫. 热管检漏技术研究[J]. 真空, 2019, 56(4): 6-9.
[5]	邢银龙, 李波, 吴杰峰, 刘志宏, 周能涛. ITER绝缘线圈氦质谱压力检测优化分析[J]. 真空, 2019, 56(4): 15-18.
[6]	刘兴悦, 王振, 窦仁超, 崔寓淏, 杨定魁. 基于莱宝检漏仪的航天器总漏率测试技术研究[J]. 真空, 2019, 56(2): 62-65.
[7]	亚历山德罗·阿巴特科拉. 一种用于粒子加速器的新型高流导离子泵[J]. 真空, 2019, 56(1): 16-19.
[8]	武越, 鄂东梅, 杜鹏, 郭子寅, 陈时雨, 王晶 . 航天器密封舱连接处漏率检测方法[J]. 真空, 2018, 55(6): 1-4.